Technicolor - Thomson ST516 Benutzerhandbuch
E-DOC-CTC-20061027-0003 v2.0
NAT Commands
578
protocol
The IP protocol to be used as filter for inbound/outbound traffic.
The NAT map only applies if the protocol of the IP packet matches
the map protocol.
Select an IP protocol (see
The NAT map only applies if the protocol of the IP packet matches
the map protocol.
Select an IP protocol (see
)
or, alternatively, type the protocol number.
The default is
The default is
0
(meaning any protocol).
OPTIONAL
outside_port
The outside port number or range (only for maps of type
napt
).
>
For a NAPT map:
Represents the range of TCP/UDP ports to be used as dynamic
port range during the NAPT process.
port range during the NAPT process.
>
For a port-shifting map:
Represents the source port(s) to be translated (shifted) into
inside_port
.
Allowed values are:
>
TCP/UDP port range [P-Q] (with Q > P)
>
TCP/UDP port number (only for port-shifting maps).
OPTIONAL
for NAPT
map.
for NAPT
map.
REQUIRED
for port-
shifting map.
for port-
shifting map.
inside_port
The inside port number or range (only for maps of type
napt
).
If this parameter is specified for a map of type
napt
, then this map
is a port-shifting map.
Represents the target TCP/UDP ports to which the traffic has to be
shifted.
Allowed values are:
Represents the target TCP/UDP ports to which the traffic has to be
shifted.
Allowed values are:
>
TCP/UDP port range [P-Q] (with Q > P)
>
TCP/UDP port number (only for port-shifting maps).
Note
The size of
inside_port
must be identical to the size of
outside_port
.
REQUIRED
for port-
shifting map
for port-
shifting map
mode
The mode to create the portmap.
Choose between:
Choose between:
>
auto
>
inbound
>
outbound.
The standard is
auto
.
OPTIONAL