Technicolor - Thomson 545/570 Benutzerhandbuch
5 SpeedTouch™ Web Interface
E-DOC-CTC-20030814-0001 v1.0
59
NAPT
C
lick this link to display the Network Address and Port Translation (NAPT) page.
This page allows you to:
•
View or add/delete specific static NAPT entries:
To add static NAPT entries proceed as follows:
1
Click New.
2
Specify the outside address and inside address for the entry as well as the
protocol and port to which the entry applies.
protocol and port to which the entry applies.
Note
If the NAPT entry is applied to a connection's dynamically
assigned local peer IP address, you should specify 0.0.0.0 as the
outside address.
assigned local peer IP address, you should specify 0.0.0.0 as the
outside address.
3
Click Apply to add the entry to the table.
Instead of manually configuring the required NAPT entries, the NAPT Manager
allows you to configure the SpeedTouch™ NAPT entries semi-automatically,
simply by selecting the application, requiring these NAPT entries. For more infor-
mation, see
allows you to configure the SpeedTouch™ NAPT entries semi-automatically,
simply by selecting the application, requiring these NAPT entries. For more infor-
mation, see
•
View or add/delete Multi-NAT entries:
Multi-NAT is also commonly known as Basic NAT (IETF).
To add Multi-NAT entries proceed as follows:
To add Multi-NAT entries proceed as follows:
1
Click New.
2
Specify the inside address and put the desired range between brackets e.g.
10.0.0.[1-10]. Specify the outside address and interface.
10.0.0.[1-10]. Specify the outside address and interface.
3
Click Apply.