Technicolor - Thomson 780 (WL) Benutzerhandbuch
38
E-DOC-CTC-20051017-0153 v1.0
Chapter 4
Voice over IP
4.1 Telephony Setup
Telephony installation
The SpeedTouch™ is equipped to connect one or two analogue phones or faxes.
Use a phone cable with RJ-11 connectors to:
1
Wire the SpeedTouch™ Phone port(s) to your phone(s) or fax.
2
If your SpeedTouch has a black-coloured port labeled "PSTN", you must
connect this port to the telephone output of your DSL splitter to allow regular
phone calls with the same telephone set. In the other case, no additional
connections are needed.
connect this port to the telephone output of your DSL splitter to allow regular
phone calls with the same telephone set. In the other case, no additional
connections are needed.
Telephony configuration
The telephony service might already have been configured on your SpeedTouch™
during initial setup.
during initial setup.
If not, follow the instructions below:
This is only required if you still want to make phone calls using the
regular telephone line.
regular telephone line.
!
Be aware that, if the PSTN port (if provided) is not wired to your
telephone wall outlet or distributed filter, emergency calls are not
always possible!
telephone wall outlet or distributed filter, emergency calls are not
always possible!
!
As distributed filters are country-specific, you cannot use the device
everywhere.
everywhere.
4
3
2
1
ETHERNET
1
4
3
2
DSL
PSTN
PHONE
1
2
RESET
USB
Your Internet connection must be up and running before you can configure
Internet telephony.
Internet telephony.