Westell Technologies 6100 Benutzerhandbuch

 

 

 

 

 

030-300411 Rev. A 

57 

July 2004 

 Westell (Models 6000, 6100, 6110)

 User Guide 

 
The following settings will be displayed if you select DHCP Configuration from the Configuration menu. 
 

 

 
 
 
DHCP Server 

This setting allows the ADSL router to automatically assign IP addresses to 
local devices connected on the LAN. Westell advises setting this to enabled for 
the private LAN. 
Off = DHCP Server is disabled 
Private LAN = DHCP addresses will be saved into the Private LAN 
configuration. 
Public LAN = DHCP addresses will be saved into the Public LAN 
configuration. This option is only available if the Public LAN DHCP server is 
enabled.  
 
NOTE: These addresses will be overwritten if the Internet Service Provider 
supports dynamic setting of these values. 

DHCP Start Address 

Factory Default = 192.168.1.15 
This field displays the first IP address that the DHCP server will provide. The 
DHCP Start Address must be within the IP address and lower than the DHCP 
End Address. You may use any number from 0 to 254 in this address. 

DHCP End Address 

Factory Default = 192.168.1.47 
This field displays the last IP address that the DHCP server will provide. The 
DHCP End Address must be within the IP address and higher than the DHCP 
Start Address. You may use any number from 0 to 254 in this address. 

DHCP Lease Time 

Factory Default = 01:00:00:00  
Displays the amount of time the provided addresses will be valid, after which 
the DHCP client will usually re-submit a request. 
 
NOTE: DHCP Lease Time is displayed in the format (dd:hh:mm:ss)*. This 
value must be greater than 10 seconds. Seconds must be between 0 and 59, 
minutes must be between 0 and 59, and hours must be between 0 and 23. 
*(dd = days, hh = hours, mm = minutes, ss = seconds)