HP (Hewlett-Packard) T1453-90001 Benutzerhandbuch
Using lanadmin -V to Administer VLANs
Using the lanadmin -V Command for Administering VLANs
Chapter 5
49
CONF_TOS or CONF_PRI)
[pri_override <level>(CONF_PRI,IP_HEADER or
CONF_TOS)] <vppa>
-V scan
-V info <vppa>
-V basevppa
-V help
Using lanadmin to Create a VLAN
Assume that the system has the following configuration as shown by the
lanscan
command output.
lanscan
Hardware Station
Crd Hdw
Net-Interface
NM
MAC
HP-DLPI DLPI
Path
Address
In# State
NamePPA
ID
Type Support Mjr#
1/2/3
0x001083FF9951 0
UP
lan0
snap0
1 ETHER
Yes
119
1/2/4
0x006023456789 1
DOWN
lan1
snap1
2 ETHER Yes
119
To configure a VPPA with VLAN ID 454 and a priority of 6 on “lan0”,
execute the following command.
execute the following command.
lanadmin -V create vlanid 454 pri 6 0
Successfully configured
lan5000: vlanid 454 name UNNAMED pri 6 tos 0 tos_override IP_HEADER pri_override
CONF_PRI ppa 0
This command created a VLAN “lan5000” on top of the physical interface
lan0. The PPA associated with this VLAN, 5000, is referred to as a
VPPA, short for Virtual PPA. Note: the parameters that were not
specified in the command have been assigned default values.
lan0. The PPA associated with this VLAN, 5000, is referred to as a
VPPA, short for Virtual PPA. Note: the parameters that were not
specified in the command have been assigned default values.
Displaying a VLAN and its Properties
You can use the default lanscan command to view all the interfaces as
follows.
follows.
lanscan
VLAN0 0x001083FF9951 5000 UP
lan5000snap5000 14
ETHER
Yes
119
1/2/4 0x006023456789 1
DOWN
lan1
snap1
2
ETHER Yes
119