Fujitsu V01 Benutzerhandbuch

15 

Equipment Operation 

This section explains how to operate IP-900 series Software. 

 
The Software can be operated through the Web screen or the front panel. 

2.2.1  Operation through Web Screen 

All IP-900 series settings and status information can be checked through the Web screen.  See Chapter 

3, “Web Operation,” for more information. 

2.2.2  Notes 

◆In the case of failure in automatic acquisition of an IP address 

When IP-900 series starts, the LAN port: 

(1) Cannot access the DHCP server 

(2) Attempts to but fails to set up a PPPoE connection. 

If the conditions in (1) and (2) above are met, all 0s (zero) are displayed and IP address 

acquisition is repeated. 

Take proper corrective action such as reviewing the settings on the DHCP and PPPoE servers or 

the IP address setting on IP-900 series.  (See also Section 5.1, “Troubleshooting.”) 

◆Forcibly changing to the fixed IP address from DHCP, PPPoE 

Start the IP-900 series by turning on the power while holding down the MNT button (for about 10 

seconds) until the RDY LED lamp starts blinking in orange.  For this startup, the IP address and 

subnet mask are assumed temporarily restored to the settings at shipment from the factory (LAN 

port with an IP address of 10.0.0.1 and a subnet mask of 255.0.0.0). 

Use this method to make the IP-900 series initial settings from a PC (*). 

 

* When running the IP-900 series product with the default IP address, ensure that it is disconnected 

from your network. 

 

After configuring the settings as suitable for your network, connect the product to your network.  

Having the product is connected to your network while the default settings are left unchanged may 
cause unexpected problems on your network. 

If you started the product while holding down the MNT button, set the IP address and subnet 

mask of the PC as follows: 

-  LAN port IP address: 10.aaa.bbb.ccc 
(aaa and bbb can be any number from 0 to 255 and ccc can be any number from 2 to 255.  
Note, however, that the resulting address must be other than 10.255.255.255.) 
-  LAN port subnet mask: 255.0.0.0