Apple bCool XG1 Benutzerhandbuch

•

Adjust ‘Brightness’, ‘Contrast or ‘Colour tracking’ (see ’Picture adjustment’ under ‘Operation’ -
‘On Screen Display Menu’).

•

Reset all projector settings in the ‘Setup’ menu (‘Factory settings’).

–

Image is not focused.

•

Adjust focus ring.

–

Distance between projector and screen is not correct.

•

Adjust the distance between the projector and the screen.

–

Signal cable is not correctly connected.

•

Connect signal cable correctly.

–

Signal cable is not correctly connected.

•

Connect signal cable correctly.

–

Audio cable is not correctly connected.

•

Connect audio cable correctly.

–

Volume is not adjusted properly.

•

Adjust volume.

–

(A/V-)Mute active.

•

Cancel (A/V-)Mute.

–

Distance is too great.

•

Reduce distance.

–

Batteries are exhausted.

•

Replace batteries (see ‘Inserting the batteries in the remote control’).

–

IR sensor is obstructed.

•

Remove obstacle.

Lamp indicator
–

Red blinking (0.5sec. On, 0.5sec. Off): lamp start has failed.
• Disconnect projector from the mains. Reconnect and restart. If this does not solve the

problem, replace the lamp. See ’Maintenance.’

–

Red blinking (1sec. On, 1sec. Off): the fans are locked.
• The projector will automatically shut down. If this problem persists, contact service center.

Temp. (temperature) indicator
–

Lights up red: temperature error.
• Disconnect projector from the mains. Reconnect and restart. If this does not solve the

problem, contact your service centre.

Standby indicator (text on Standby button/ring around Standby button)
–

Lights up green: Power on mode.

–

Green blinking: warming up in Power on mode.

–

Lights up red:: Standby mode.

–

Red blinking: cooling down in Power off mode.

Poor colour

Image is blurred

Picture rolls

No sound

The projector does not

react to commands from

the remote control

Indicators

Philips Multimedia Projector

English User guide bCool XG1

7.Troubleshooting