Benq W20000 Benutzerhandbuch

24 

Using the projector  

Eng
lish

Using the preset and user modes

Selecting a preset mode

The projector is preset with several pre-defined picture modes so that you can choose one to suit your operating 
environment and input source picture type.
To select a picture mode that suits your need:

•

Using the remote control

1.

Press PRESET repeatedly or USER 1, USER 2/ISF NIGHT, USER 3/ISF 
DAY on the remote control, or PRESET MODE on the projector 
repeatedly until your desired mode is selected.

•

Using  the  OSD  menu

1.

Press MENU and then press  /  until the Picture -- Basic menu is 
highlighted.

2.

Press   to highlight Picture Mode.

3.

Press  /  until your desired mode is selected.

These modes consist of preset values suitable for various projection situations 
as described below:
•

Cinema: with well-balanced color saturation and contrast with a low 
brightness level. This is most suitable for enjoying movies in a totally 
dark environment (as you would find in a commercial cinema). 

•

Dynamic: Maximizes the brightness of the projected image. This mode is 
suitable for environments where extra-high brightness is required, such 
as using the projector in well lit rooms.

•

Standard: Is slightly brighter than Cinema mode, and suitable for use in 
rooms where there is a small amount of ambient light.

•

User 1/User 2/User 3: Recalls the customized settings. See 

"Setting the 

User 1/User 2/User 3 mode" on page 25

 for details.

Fine-tuning the selected picture mode

The pre-defined picture mode settings can be altered via the available items shown in the Picture -- Basic and 
Picture -- Advanced menus. 

To fine-tune the picture mode:

1.

Press MENU and then press  /  until the Picture -- Basic or Picture -- Advanced menu is highlighted.

2.

Press   to highlight the item you want to adjust (from among Brightness, Contrast, Color, Tint, 
Sharpness, Black Level, Clarity Control, Color Temperature, Gamma Selection, Brilliant Color, Color 
Management, IRIS) and press  /  to set your desired value. Your selection is automatically stored in the 
projector and associated with that input source.
See 

"Fine-tuning the picture quality" on page 26

 and 

"Advanced picture quality controls" on page 27

 for 

details.

Each time you change the picture mode, the projector also changes the setting to the one which was last set for 
that particular picture mode on that particular input. If you change the input source, the most recently used 
picture mode and settings for that input and resolution will be restored.

2

3

W20000-en.book  Page 24  Monday, October 22, 2007  3:35 PM