Benq W1080ST Benutzerhandbuch

  25

  Using the projector

Selecting an input source

The projector can be connected to multiple equipment at the same time. 
When the projector is first turned on, it will attempt to reconnect with 
the input source which was in use when the projector was last shut 
down.

To select the video source:

•  Using the remote control or projector
1. Press SOURCE on the projector or remote control. A source 

selection bar displays. 

2. Press  /  until your desired signal is selected and press MODE/

ENTER.

•  Using the OSD menu
1. Press MENU/EXIT and then press  /  until the System Setup : Basic menu is highlighted.
2. Press  

to 

highlight 

Input Source and press MODE/ENTER. The source selection bar displays.

3. Press  /  repeatedly until your desired signal is selected and press MODE/ENTER.

Once detected, the selected source information will display on the screen for seconds. If there are 
multiple pieces of equipment connected to the projector, you can go back to the source selection bar 
again to search for other signals.

You can also rename the source:

1. Press MENU/EXIT and then press  /  until the System Setup : Basic menu is highlighted.
2. Press  

to 

highlight 

Source Rename and press MODE/ENTER. The Source Rename page 

displays.

3. Press  / / /  until your desired character is selected and press MODE/ENTER.
•  If you want the projector to automatically search for the signals, select On in the System Setup : 

Basic > Auto Source Search menu.

Fine-tuning the image size and clarity

NOTE: When 
automatically 

searching for a 

valid input source, 
the projector 

cycles through 

the available 
signals following 

the sequence 

from top to 
bottom as the 

source selection 

bar shows.

1. Adjust the projected picture to the size 

that you need using the zoom ring. 

2. Sharpen the picture by rotating the focus 

ring.