Benq MP575 Benutzerhandbuch

Operation

42

Controlling the projector through a Lan 

environment (MP526/MP576 only)

Lan Control Settings allow you to manage the projector from a computer using a web 
browser when the computer and the projector are properly connected to the same local 
area network.

Configuring the Lan Control Settings

If you are in a DHCP environment:

1.

Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector 
and the other end to the RJ45 port.

2.

Press Menu/Exit and then press  /  until the SYSTEM SETUP: Advanced menu 
is highlighted.

3.

Press  

to 

highlight 

Lan Control Settings and press Mode/Enter. The Lan Control 

Settings page displays.

4.

Press   to highlight Control By and press  /  to select RJ45.

5.

Press   to highlight DHCP and press  /  to select On.

6.

Press   to highlight Apply and press Mode/Enter.

7.

Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings 
page.

8.

The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings 
will be displayed. Note down the IP address displayed in the Projector IP Address 
row.

If you are in a non-DHCP environment:

1.

Repeat steps 1-4 above.

2.

Press   to highlight DHCP and press  /  to select Off.

3.

Contact your ITS administrator for information on the Projector IP Address, 
Subnet Mask, Default Gateway, and DNS Server settings.

4.

Press   to select the item you want to modify and press Mode/Enter.

5.

Press  /  to move the cursor and then press  /  to enter the value.

6.

To save the setting, press Mode/Enter. If you do not want to save the setting, press 
Menu/Exit.

7.

Press   to highlight Apply and press Mode/Enter.