Benq MP525P Benutzerhandbuch

Introduction

Remote control effective range

Infra-Red (IR) remote control sensor is located on the
front of the projector. The remote control must be held at
an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly.
The distance between the remote control and the sensor
should not exceed

8 meters (~ 26 feet).

Make sure that there are no obstacles between the remote
control and the IR sensor on the projector that might
obstruct the infra-red beam.

Replacing the remote control battery

Pull out the battery holder.

Please follow the illustrated instructions. Push and hold the
locking arm while pulling out the battery holder.

Insert the new battery in the holder. Note the
positive polarity should face outward.

Push the holder into the remote control.

• Avoid excessive heat and humidity.

• There may be battery damage if the battery is incorrectly

replaced.

• Replace only with the same or equivalent type

recommended by the battery manufacturer.

• Dispose of the used battery according to the battery

manufacturer's instructions.

• Never throw a battery into a fire. There may be danger of an explosion.

• If the battery is dead or if you will not be using the remote control for a long time, remove

the battery to prevent damage to the remote control from possible battery leakage.

13. Timer On

Activates or displays an on-screen
timer based on your own timer
setting.

"Setting the presentation timer" on page
37

14. Timer Set up

Enters presentation timer setting
directly.

"Setting the presentation timer" on page
37

15. Page Up/Down

(This function is not available with the
MP5 series models.)

Approx. 1

5°