Runco VX-22I Benutzerhandbuch
38
Runco VX-22i Installation/Operation Manual
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Installing and
Adjusting the
CineWide Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
adjust the anamorphic lens.
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)
The VX-22i Anamorphic lens mount kit consists of everything shown in Figure 3-18. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23RUNCO.
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23RUNCO.
Figure 3-18. VX-22i Anamorphic Lens Mounting Assembly - Exploded View
1.
Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
Anamorphic Lens Holder (item #5).
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
➤
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw and Washer
(2x)
T-Screw and Washer
(2x)
T-Screw and
Washer (2x)
Washer (2x)
Pitch Adjustment
Anamorphic Lens
Holder
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
and Washer (2x)
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Fixed CineWide Base Plate
Yaw/X Adjustment
Lever (2x)
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
T-Nut (2x)
10
Anamorphic Lens
Set Screw
Set Screw