Sanyo PLC-XL50 Benutzerhandbuch

POWER

WARNING 

LAMP 

REPLACE

The projector is off. (The AC power cord is unplugged.)

The  projector  is  preparing  for  stand-by  or  the  projection  lamp  is 

being cooled down. The projector cannot be turned on until cooling is 

completed.

The projector is ready to be turned on with the ON/STAND-BY button.

The projector is operating normally.

The projector is in the Power management mode.

The temperature inside the projector is abnormally high. The projector 

cannot be turned on. When the projector is cooled down enough and 

the  temperature  returns  to  normal,  the  POWER  indicator  lights  red 

and  the  projector  can  be  turned  on.  (The WARNING  indicator  keeps 

blinking.) Check and clean the air filters.

The  projector  has  been  cooled  down  enough  and  the  temperature 

returns  to  normal. When  turning  on  the  projector,  the WARNING 

indicator stops blinking. Check and clean the air filters.

The projector detects an abnormal condition and cannot be turned on. 

Unplug the AC power cord and plug it again to turn on the projector. If 

the projector is turned off again, unplug the AC power cord and contact 

the dealer or the service center for service and checkup. Do not leave 

the projector on. It may cause an electric shock or a fire hazard.

Check the indicators for projector condition.  For Alarm indicator, see pages 55-56.

• • • green.

• • • red

• • • off

• • • blinks green.

✽

When the projection lamp reaches the end of its life, the LAMP REPLACE indicator lights yellow. 

When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp 

replacement counter after replacing the lamp. See pages 62-63.

• • • blinks red.

✽

✽

✽

✽

✽

✽

✽