Sanyo PLC-XW57 Benutzerhandbuch

14

This projector uses nominal input voltages of 100-10 V 
or 00-40 V AC and it automatically selects the correct 
input  voltage.    It  is  designed  to  work  with  single-phase 
power  systems  having  a  grounded  neutral  conductor.  
To  reduce  the  risk  of  electrical  shock,  do  not  plug  into 
any other type of power system.
If you are not sure of the type of power being supplied, 
consult your authorized dealer or service station.
Connect  the  projector  with  all  peripheral  equipment 
before  turning  the  projector  on.  (See  pages  15-17  for 
connection.) 

Note: 

Unplug the AC power cord when the projector is not in   

               use.  When this projector is connected to an outlet with 
               the AC power cord, it is in Stand-by mode and consumes  
               a little electric power. 

 

 CAUTION

The AC  outlet  must  be  near  this  equipment  and  must  be 
easily accessible.

Connect the AC power cord (supplied) to the 
projector.

To the AC outlet.
(200 - 240 V AC)

To power cord 
connector on your 
projector.

Ground

To the AC outlet.
(120 V AC)

To the AC outlet.
(200 - 240 V AC)

AC power cord must meet requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.