Sanyo PLC-WU3800 Betriebsanweisung

⑥  S-VIDEO IN
  Connect the S-VIDEO output signal from video 

equipment to this jack (p.16).

⑨

 

  Connect the audio output signal from video 

equipment connected to ⑥ or ⑩ to this jack. 
For a mono audio signal (a single audio jack), 

connect it to the L (MONO) jack (p.16).

⑧ COMPUTER 1 COMPONENT / COMPUTER  

  Connect the audio output (stereo) from a 

computer or video equipment connected to ②, 
③ or ④ to this jack. (pp.15, 17)

⑩

 

  Connect the composite video output signal to 

this jack (p.16).

②

 

  Connect output signal from a computer, RGB scart 

21-pin video output or component video output to 

this terminal (pp.15,17).

⑦

 

  Connect an external audio amplifier to this jack 

(pp.15 -17).

  This terminal outputs sound from AUDIO IN terminal 

(⑧ or ⑨).

     Never plug headphones and earphones into AUDIO 

OUT jack.

⑤

 

  Connect the LAN cable (refer to the owner’s manual 

of “Network Set-up and Operation”).

②

③

①

④

⑦

⑧

⑨

①  CONTROL PORT
  When controlling the projector with RS-232C, 

connect the control equipment to this connector with 

the serial control cable.

⑩

⑤

⑥

④

 

  Connect the HDMI signal (including sound signal) 

from video equipment or the DVI signal from 

computer to this terminal (pp.15, 17).

③

 

  – Connect computer output to this terminal (p.15).

  – This terminal can be used to output the incoming 

analog RGB signal and component signals from 

COMPUTER IN 1/COMPONENT IN terminal to the 

other monitor (p.15).

*  

  is registered trademarks of HDMI    

                  Licensing, LLC.

 *