Vidikron Vision 15 Benutzerhandbuch

• Phase: Adjust the phase if the image (usually from an RGB source) shows shimmer or 

“noise.” Pixel phase adjusts the phase of the pixel sampling clock relative to the incoming 
signal. The effect of this control is similar to that of a tracking control on a VCR.

For best results, use a good test pattern such as a smooth gray consisting of a clear pattern 
of black and white pixels, or a similar “half on, half off” graphic image. (You may find that 
you can stabilize the image at more than one point. Use either setting in this case.)

• Reset: Select Reset from the YUV/RGB Adjust menu to restore the position, clock and 

phase settings to their factory-default values. 

OSD Timeout: This timer controls how long the menus remain on-screen after selecting 
them. Select a time-out period of 0, 5, 15 or 60 seconds. When you set the OSD Timeout to 0, 
the menus remain on-screen until you hide them by pressing MENU. 

Vertical Correction (Vision 15ET/CineWide only): To achieve the proper image geometry 
with the secondary anamorphic lens, select Vertical Correction from the Installation menu. 
Then, use the 

 or 

 button to change the native aspect ratio of the display, in small 

increments. 

The range is from 0 through 5 in increments of 1. Each increment reduces the image height 
by one percent. A value of 5, for example, reduces the image height by 5 percent.

Select Information from the Main Menu to see projector status information: the 
currently-active source, input signal resolution, aspect ratio, picture memory and lamp 
usage. This menu also displays the projector serial number.

Should you ever need to contact Vidikron Technical Support, this information will help them 
answer your questions or resolve product performance issues. 

➤