Sony SRX-R105 Benutzerhandbuch

GB 

12

Location and Function of Controls

  

Ch
apt

er 1  Ov

e

rv

ie

w

B: Selects the signal input from the connectors on the 

optional input board installed in the INPUT B section.

C: Selects the signal input from the connectors on the 

optional input board installed in the INPUT C section.

D: Selects the signal input from the connectors on the 

optional input board installed in the INPUT D section.

Use these buttons together with the PICTURE CONT 
buttons (

6) or SCREEN SEL buttons (7).

Example: When you want to increase the contrast of the 

signal input from the INPUT A board, press INPUT 
SEL A button, then press the CONTR + button.

f PICTURE CONT (Picture control) buttons
Adjust the projected picture quality.
CONTR+/–: Adjust the contrast. Pressing the + button 

increases the contrast. Pressing the – button decreases 
the contrast.

BRIGHT +/–: Adjust the picture brightness. Pressing the 

+ button makes the picture brighter. Pressing the – 
button makes the picture darker.

SHARP +/–: Adjust the picture sharpness. Pressing the + 

button makes the picture sharper. Pressing the – 
button makes the picture softer.

In multiple screen mode, adjustment can be made for the 
input signal from each input board. 
Select the input signal with the INPUT SEL A/B/C/D 
buttons (

5), then adjust the picture with these buttons. In 

single-screen mode, you need not press the INPUT SEL 
button. 
Example: When you want to increase the contrast for the 

signal input from the INPUT A board, press the 
INPUT SEL A button, then press the CONTR + 
button.

g SCREEN SEL buttons
In multiple screen mode, select one of the divided screens 
where you want to project the selected signal from each 
input board. 

Select the input signal with one of the INPUT SEL A/B/C/
D buttons (

5), then select the screen with one of these 

buttons.
Example: When you want to project the signal input from 

the INPUT B board on Screen 3 (lower left screen), 
press the INPUT SEL B button, then press the 
SCREEN SEL 3 button.

h LENS CONT buttons
FOCUS +/–: Adjust the focus. Pressing the + button 

focuses on a forward picture. Pressing the – button 
focuses on a picture further back.

ZOOM +/–: Adjust the picture size. Pressing the + button 

enlarges the picture size. Pressing the – button 
reduces the picture size.

SHIFT +/–: Adjust the vertical picture position. Pressing 

the + button moves the picture upward. Pressing the – 
button moves the picture downward.

Remove the lid, then install the two size AA (R6) 
batteries (supplied) with the correct polarity.

Replace the lid.

• Be sure that there is nothing to obstruct the infrared 

beam between the Remote Commander and the 
projector. Direct the Remote Commander toward one of 
the remote control detectors at the front and rear of the 
projector when operating.

• The operation range is limited. The shorter the distance 

between the Remote Commander and the projector, the 
wider the angle within which the Commander can 
control the projector.

Push the knob to open 
the lid.

Be sure to install the battery 
from the – side.