Epson 7850p Benutzerhandbuch

■

Progressive

 (in the Advanced 1 menu)

This setting should normally be left at its default setting (

Video

 

or 

Film/Auto

). Converts interlaced signals to progressive signals. 

When set to 

OFF

, interlaced signals are processed without 

conversion (available for video signals only). 

■

BNC Sync Termination 

(in the Advanced 2 menu)

This setting should normally be left 

Off

 (for TTL input). If an 

analog (75-ohm) terminator is required, as for a switcher, change 
the setting to 

ON

. 

These options let you set up the projector so it can be monitored and 
controlled from a remote computer (see Chapter 7). 

■

Standby Mode 

(in the Advanced 1 menu)

Select 

Network ON

 to enable the projector to be monitored over 

a network when it’s in standby mode. 

■

Network 

(in the Advanced 2 menu)

Used for managing the projector over a wired network (see 
Chapter 7). If the network assigns addresses automatically, turn 
on 

DHCP

. Otherwise, turn off 

DHCP

 and enter the projector’s 

IP 

Address

, 

Subnet Mask

, and 

Gateway Address

, if applicable. 

If you want to monitor the projector using a network 
management utility, select 

SNMP

 and enter at least one trap IP 

address. 

■

COM Port

 (in the Advanced 2 menu)

Used for communicating with a computer running the EMP 
Link21L utility software. Select 

RS-232C

 or 

USB

, depending on 

the port that’s being used for communication with the computer. 
Turn off the projector and then turn it back on for the new 
setting to take effect. 

Network ON

Num

Num 

button

Zero