Epson 7850p Benutzerhandbuch

■

Make sure that you’ve connected the projector to the network and 
configured it correctly; see page 142 for information about setting 
up the projector for a wired network, or page 70 for information 
about setting it up for a wireless network. Also, make sure you’ve 
registered the projector with EMP Monitor. See page 144.

■

Make sure that Standby Mode in the projector’s Advanced 1 
menu is set to 

Network ON

.

■

If the computer you are using is running Windows XP or 2000, 
you must be logged in as the Administrator.

■

Try restarting your computer.

■

Make sure you’ve installed the EPSON 802.11b card correctly in 
the projector; see page 68 for instructions. If you have to reinstall 
the card, restart NS Connection or the program will not be able to 
detect the projector.

■

Make sure your projector and computer are configured correctly. 
See page 70 (Ad Hoc mode) or page 77 (Access Point mode) or 
details.

■

Make sure that you have sufficient wireless signal strength (above 
50 per cent). If you have a Macintosh, check the AirPort icon on 
the Macintosh menu bar. For Windows, see the documentation 
for your computer’s wireless card or adapter for details.

■

Make sure you aren’t projecting one of the EasyMP configuration 
screens. (You should see a message that the projector is ready to 
connect.) If you have to exit a configuration screen, restart 
NS Connection.

■

If the projector is configured for Access Point mode and you’re 
using DHCP, allow a minute or two for your projector to appear. 
Sometimes it takes the server a little while to pick up the IP 
address.