Epson EB-G5450WU Benutzerhandbuch

Status

Cause

Remedy or Status

Low Air Flow

(This is not an abnormality. However, projection stops automatically if the airflow falls any further.)
The message "The air filter is clogged. Clean or replace the air filter. " is displayed. Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.

• If the air filter is clogged, clean or replace it. s 

If the Low Air Flow status continues after cleaning the air filter, replace the air filter with a new one. s 

If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide s 

Air Filter Notice

The following message may also be displayed: "Time to clean the air filter. Clean or replace the air filter." Clean the air filter.
s

 

If the air filter is stained yellow with tobacco smoke and cannot be cleaned, replace it with a new one.
The indicators or messages regarding "Air Filter Notice" are displayed only when Air Filter Notice is set to On, on the
configuration menu's Extended menu. s 

q

• If  the  projector  is  not  operating  properly,  even  though  the  indicators  are  all  showing  normal,  refer  to  “When  the  Indicators  Provide  No  Help”.

s

 

• If  the  error  is not  indicated in this table, stop  using  the  projector, disconnect  the  power  cable  from  the  electrical  outlet, and  contact  your  local dealer  or  the

nearest  address  provided  in  the  Support  and  Service  Guide.  s