Epson EB-W8 Benutzerhandbuch
You can monitor and control the projector from a computer, via USB.
This is done by connecting the projector and the computer with a USB
cable, and entering communication commands (ESC/VP21 commands).
This is done by connecting the projector and the computer with a USB
cable, and entering communication commands (ESC/VP21 commands).
Before You Begin
To monitor and control the projector with ESC/VP21 commands, the
following preparations must be carried out.
following preparations must be carried out.
Procedure
A
Install the USB communication driver (EPSON USB-COM
Driver) to your computer. For information about the EPSON
USB-COM Driver, contact your local dealer or the nearest
address provided in the Support and Service Guide.
Driver) to your computer. For information about the EPSON
USB-COM Driver, contact your local dealer or the nearest
address provided in the Support and Service Guide.
s
B
From the projector's Configuration menu, set Extended -
USB Type B to Wireless Mouse or Page Up/Down.
USB Type B to Wireless Mouse or Page Up/Down.
C
Similarly, set Link 21L to On from Extended menu.
D
Connect the computer's USB port to the projector's
USB(TypeB) port with a USB cable.
USB(TypeB) port with a USB cable.
From second time on, start from step two.
Command List
When the power ON command is transmitted to the projector, the
power turns on and it enters warm-up mode. When the projector's
power has turned on, a colon ‘:’ (3Ah) is returned.
power turns on and it enters warm-up mode. When the projector's
power has turned on, a colon ‘:’ (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ‘:’, and then accepts the next command.
returns a ‘:’, and then accepts the next command.
If the command being processed terminates abnormally, an error
message is output and a ‘:’ is returned.
message is output and a ‘:’ is returned.
Item
Command
Power ON/OFF
On
PWR ON
Off
PWR OFF
Signal selection
Computer
Auto
SOURCE 1F
RGB
SOURCE 11
HDMI (EB-W8/X8 only)
SOURCE 30
Video
SOURCE 41
S-Video
SOURCE 42
USB Display
SOURCE 51
USB (EB-X8/S8 only)
SOURCE 52
A/V Mute On/Off
On
MUTE ON
Off
MUTE OFF
A/V Mute selection
Black
MSEL 00
Blue
MSEL 01
Logo
MSEL 02
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
transmit.
Communications protocol
• Default baud rate setting: 9600bps (the speed during communication
complies with the USB 1.1 standard.)
• Data length: 8 bit
• Parity: None
• Stop-bit: 1 bit
• Flow control: None
• Parity: None
• Stop-bit: 1 bit
• Flow control: None
Monitoring and Controlling the Projector Using a Computer (ESC/VP21 Commands)
87