JVC DLA-SH4KNL Merkblatt

Positioning Pin

Lens Cap

Lens Sheet

Front Cover

Top Panel

Positioning Pin

CN80Z0

CN80F0

Clamp

Zoom Motor Cable

Motor

Lens Cap

Shift Lock Screw

Mounting the Lens



When a zoom lens is used



When a short focal length lens is used

● When removing the lens cap, pull out without turning it.
● Do not scratch or knock the lens surface.

● Connect the zoom motor cable (3 pin) to “CN80Z0”, and the focus motor cable (2 pin) to “CN80F0”.

● Connect the focus motor cable (2 pin) to “CN80F0”.

●  Insert the lens with the motor facing upward.
●  Align the positioning pin of the projector (1 each on left and right sides) with the positioning pin
  of the lens.

Remove the lens sheet attached to the lens mount at the front cover

Remove the lens cap of the end to be inserted into the projector

Insert lens into the mounting hole

Tighten the 5 screws using the hexagonal wrench with a diagonal size of 3 mm (Bondhus

type recommended) to fasten the lens

Clamp the motor cable

Connect the motor cable

● Retain these shift lock screws for future use during transportation.

Unscrew the 2 shift lock screw

NOTE:

● Remove the top panel if possible to

  ease the mounting process. For details on
  how to remove the top panel, please consult
  your authorized dealer or refer to the service
  manual.

● Remove the lens cap before projection.

Attach the front cover, and fasten using the 6 screws using a Phillips screwdriver

CAUTION: Before attaching the lens, check to make sure that the power of the projector is not turned on and the

power cord is not connected. Failure to do so may cause electric shock or injuries.

Unscrew the 6 screws using a Phillips screwdriver to remove the front cover

Focus Motor
Cable

CAUTION:

● Keep the cable away from the motor gear

when clamping the motor cable.

CMY

SH4KNL_EN_Lens_sheet-2.pdf 2008/06/04 21:08:06