Hitachi CP-X268AWF Benutzerhandbuch

42

OPTION Menu

OPTION Menu

8VLQJWKHEXWWRQVŸźWXUQVRQRIIWKHDXWRPDWLFVLJQDOVHDUFKIXQFWLRQ

TURN ON 

Ù TURN OFF

When the TURN ON is selected, detecting no signal automatically cycles 
through input ports in the following order. The search is started from the 
current port. Then when an input is found, the projector will stop searching 
and display the image.

RGB IN1

Ö RGB IN2 Ö MIU Ö COMPONENT VIDEO Ö S-VIDEO Ö VIDEO 

8VLQJWKHEXWWRQVŸźWXUQVRQRIIWKHDXWRPDWLFNH\VWRQHIXQFWLRQ

TURN ON 

Ù TURN OFF

TURN ON : Automatic keystone distortion correction will be 
executed whenever changing the slant of the projector.
TURN OFF : This function is disabled. Please execute the AUTO 
KEYSTONE EXECUTE in the SETUP Menu for automatic keystone 
distortion correction.
 When the projector is suspended from the ceiling this feature will 
not function properly so select TURN OFF.
This function will be unavailable when Transition Detector is on (

50).

8VLQJWKHEXWWRQVŸźWXUQVRQRIIWKH$87221IXQFWLRQ

TURN ON 

Ù TURN OFF

When set to TURN ON, the lamp will only be automatically turned on when 
the Power switch is turned on after the power was turned off by Power 
switch last time. 
The lamp will not be automatically turned on when the Power switch is 
turned on if the lamp was turned off with the following procedures.
• The lamp was turned off with a remote control, projector button, or 
power turn off command.
• The lamp was turned off with an AUTO OFF function (

43).

• The lamp was turned on by an AUTO ON function and was turned 
off about 30 minutes after no signal had been detected.
When no input is detected after the power on and AUTO OFF time is set to 0, 
the projector will be turned off after about 30 minutes passed.
When no input is detected after the power on and AUTO OFF time is set to 
1 to 99, the projector will be turned off after the passed time reaches at the 
set time.
If one of the projector's buttons or the remote control buttons is pressed 
or one of the commands (except get commands) is transmitted from the 
control port during the corresponding time, projector will not be turned off.

With the OPTION menu, the items shown in the table below can 
be performed. 
6HOHFWDQLWHPXVLQJWKHFXUVRUEXWWRQVŸźRQWKHSURMHFWRURU
UHPRWH FRQWURO DQG SUHVV WKH FXUVRU EXWWRQ Ź RQ WKH SURMHFWRU
or remote control, or the ENTER button on the remote control to 
execute the item, except for the items LAMP TIME and FILTER 
TIME. Then perform it referring to the following table.

/'07=4)$?

2+%674'

5'.'%6

+/#)'

5'672

+0276

126+10
/+7
'#5;/'07

5%4''0

#7611((OKP

.#/26+/'J
(+.6'46+/'J

#7615'#4%*67401((
#761-';5610'67401((
#7611067401((

/;$76610
5'48+%'
5'%74+6;