Infocus SP8602 Benutzerhandbuch
6
Connector panel
The projector provides both computer and video connection options, including:
•
VGA computer
•
HDMI (2)
•
S-video
•
Composite video
•
Component video (3)
•
USB port
The projector also provides the following connectors:
•
12V screen trigger outputs (3)
•
IR Repeater input (for use with IR receivers that follow the Xantech connector
specification T=Signal, R= GND, S=12VDC)
specification T=Signal, R= GND, S=12VDC)
•
RS-232 connector for serial control. Command control codes are in the
Appendix and on our support website at www.infocus.com/support.
Appendix and on our support website at www.infocus.com/support.
12V External Trigger outputs
The three 3.5mm mini-jack 12 volt, 0.25 amp DC outputs are screen/lens triggers:
•
The “Lamp” trigger turns on when the lamp is lighted. If you connect your
projection screen to this output using the cable that came with your screen, the
screen will move down when the lamp is turned on and the screen will return
to its storage position, when the lamp is turned off.
projection screen to this output using the cable that came with your screen, the
screen will move down when the lamp is turned on and the screen will return
to its storage position, when the lamp is turned off.
•
The Letterbox “1” and “2” triggers are active when the projector is placed in
letterbox mode and are utilized for variable masking and anamorphic lens
control. (These triggers are off when SplitScreen is active.)
letterbox mode and are utilized for variable masking and anamorphic lens
control. (These triggers are off when SplitScreen is active.)
Security lock
RS-232
12V External
Trigger outputs
Trigger outputs
Composite
video
HDMI
Component
video
video
Cable cover
S-video
VGA
IR
Repeater
Repeater
USB