Infocus IN3926 Benutzerhandbuch

Turn off the projector and unplug the power cord.

Wait 60 minutes to allow the projector to cool thoroughly. 

Remove the lamp door, located on top of the projector, by removing the screw 
on the side of the lamp door, sliding the door to the left, and lifting the lamp 
door off.

Loosen the captive screws that attach the lamp housing to the projector. 

 

NOTE: If the projector is installed on a ceiling mount, be careful not to drop the 
lamp module once the captive screws are loosened.

Carefully lift the lamp straight up, off of the alignment pins; being careful not to 
pinch the lamp connector. Dispose of the lamp in an environmentally proper 
manner.

Install the new lamp module, aligning the pins properly. Be careful not to pinch 
the lamp connector.

Tighten the screws. (NOTE: If the pins have not been aligned properly, the 
screws will not tighten securely.)

Replace the lamp door by reversing step 3 and locking it back into place.

Replace the lamp door screw and tighten securely.

Plug in the power cord and press the Power button to turn the projector back on.

To reset the lamp hour timer, navigate to the Advanced Menu > Status/Service 
menu and select Reset Lamp Hours....

turn off and unplug 
projector

wait 60 minutes

loosen screws

loosen lamp door screw

Image

Setup

Status/Service

Basic Menu

Source Info...

Projector Info...

Reset Lamp Hours...

Factory Reset...

Service Code...

( 

Advanced Menu

MDL: IN3924

FW: 1.02