Infocus LP290 Benutzerhandbuch
7
SETTING UP THE PROJECTOR
1
Place the projector on a flat surface.
•
The projector must be within 6 feet (1.8 m) of your power
source and your computer.
source and your computer.
•
If you want to project from behind a translucent screen, set
up the projector behind your screen. See “Rear” on page 25
to reverse the image.
up the projector behind your screen. See “Rear” on page 25
to reverse the image.
•
If you are installing the projector on the ceiling, refer to the
installation guide that comes with the Ceiling Mount Kit for
more information. To turn the image upside down, see
“Ceiling” on page 25. The Ceiling Mount Kit is sold sepa-
rately, see “Optional Accessories” on page 41.
installation guide that comes with the Ceiling Mount Kit for
more information. To turn the image upside down, see
“Ceiling” on page 25. The Ceiling Mount Kit is sold sepa-
rately, see “Optional Accessories” on page 41.
2
Position the projector the desired distance from the screen.
NOTE: The projector must be at
least 3.6 feet (1 m) from the pro-
jection screen.
•
If the image is too big or too small, use the zoom ring to
adjust the size or move the projector forward or backward.
Figure 4 shows three projected image sizes. For more infor-
mation about image size, see “Projected Image Size” on
page 48.
adjust the size or move the projector forward or backward.
Figure 4 shows three projected image sizes. For more infor-
mation about image size, see “Projected Image Size” on
page 48.
F
IGURE
4
Projected image size at minimum zoom
3
Make sure the projector and the computer are turned off.
3.3
ft.
16
.7
ft.
8.3
ft.
3.9 ft
.
9.8 ft.
19.7 ft.