Infocus IN2114 Benutzerhandbuch

IMPORTANT: To enable network functions at all times (even when the projector 
is powered off), the Network item in the Always-On Functions submenu in the 
Setup menu must be set to Yes (not No).

Projector network functions include:

•

Configuring and controlling the projector via a web browser.

•

Failure and warning alerts via email.

•

Projector Management via SNMP.

•

Controlling the projector via Scheduling.

NOTE: Projector web pages and emails sent by the projector are always displayed 
in English language.

For network control, you can access the projector through Port 23 (Telnet). We use 
the same control codes on serial as we do over the network. InFocus network con-
trol uses the Telnet packet structure.

To use the network functions of the projector, the projector must be configured to 
suit your network. Consult with your network administrator before connecting the 
projector to your network; incorrect network configuration of the projector may 
cause problems on your network.

Properly connect projector to the network, then configure the following settings.

Use the projector's remote control or keypad to select the Network item in the 

projector's Setup menu.

If DHCP is off, select it to turn it on.

Use the projector's remote control or keypad to select the Network item in the 
projector's Setup menu.

If DHCP is on, select it to turn it off.

NOTE: If you still don’t see an IP address, go to the projector’s Setup menu, select 
Network, then turn on Show Network Messages. After exiting the menu press the 
Source button again.

Select IP Address. This will highlight the first of the four octets in the IP 
address. Press Up or Down to change the value, then press Select or Right 
when done to move to the next octet. Repeat until you have changed all four 
octets in the IP address.

Repeat the above for Subnet Mask, Default Gateway, and other settings that are 

in IP address format (to assign or change the Host Name, see Network Settings 
Page below).

You can adjust or control the projector via a network from a web browser on a com-
puter that is connected to the same network as the projector.

NOTES: 

•

To access the projector’s web pages, the projector must be connected to the 
network and connected to AC power (and if you want to access the web pages 
even when the projector is powered off, make sure that the Network item in the 
Always-On Functions submenu is set to Yes).

•

JavaScript must be enabled in your browser to use the projector web pages 
properly. If JavaScript is disabled, see the Help files for your web browser for 
details on how to enable it.

•

If no operations are performed in the web browser for approximately ten min-
utes, the system will automatically log you off.

To log into the projector web pages, follow these steps:

Make sure the projector is connected to the network and connected to AC 

power.