Infocus X1 Benutzerhandbuch
41
Red LED Behavior and Projector Errors
If the projector is not functioning properly and the LED is blinking red, con-
sult Table 3 to determine a possible cause. There are two-second pauses
between the blinking cycles. Visit www.infocus.com/service for more
details on the red LED error codes.
sult Table 3 to determine a possible cause. There are two-second pauses
between the blinking cycles. Visit www.infocus.com/service for more
details on the red LED error codes.
Table 3:
Red LED Behavior
Explanation
One (1) blink
The lamp won't strike after five (5)
attempts. Check the lamp and lamp door
installations for loose connections.
attempts. Check the lamp and lamp door
installations for loose connections.
Two (2) blinks
The lamp counter hours have exceeded
lamp life hours. Replace the lamp and
reset the lamp hours counter.
lamp life hours. Replace the lamp and
reset the lamp hours counter.
Three (3) blinks
The projector has shut down the lamp.
Check the lamp door. Replace the lamp.
Contact Technical Support (see page 24)
for repair if replacing the lamp does not
solve the problem.
Check the lamp door. Replace the lamp.
Contact Technical Support (see page 24)
for repair if replacing the lamp does not
solve the problem.
Four (4) blinks
Five (5) blinks
The projector is overheating. Check for a
blocked air vent. Contact Technical Sup-
port (see page 24) for repair if clearing
the air vents does not solve the problem.
blocked air vent. Contact Technical Sup-
port (see page 24) for repair if clearing
the air vents does not solve the problem.