Infocus IN2112 Benutzerhandbuch

Web Access - Administrator tab: Select whether or not Administrators must enter 
a password to log into the projector's web pages. If a password is required, click cre-
ate or change password to update the administrator password.

Web Access - Basic User tab: Select whether or not Basic Users must enter a pass-
word to log into the projector's web pages. If a password is required, click create or 
change password to update the basic user password.

Projector PIN tab: Allows you to turn projector PIN protection on or off, or 
change the PIN. When PIN protection is on, the current PIN must be entered when 
the projector is powered on, otherwise the projector will not operate. NOTE: PIN 
protection only applies to projector operation via the projector's keypad and remote 
control; it does not affect the projector's web pages.

This page shows a log of the 100 most recent projector events. 

Erase Log…: Click this to erase all events in the log.

This page lets you perform various network-related projector tasks. 

Save and Load Projector Configuration: These functions save and load all net-
work-related projector settings into/from a file stored on your computer. This lets 
you quickly 'clone' network settings from one projector to other projectors.

Upgrade Projector Network Firmware: Upgrades the firmware for the projector's 
network and LitePort features (this firmware is separate from the regular projector 
firmware).

Restart Projector Network Subsystem: Restarts the projector network subsystem; 
does not change any projector settings.

Network Subsystem Factory Reset: Returns all network and LitePort settings to 
default values and then restarts the projector network subsystem.

•

If network status is shown as Not Connected in the projector's Network menu, 
or the projector does not display its IP address, check the cable or the network 
configuration.

•

If your web browser displays Page Not Found or a similar error when you try 
to access the projector's web pages, verify that the 

 

projector is connected to the network (select the Network item in the 
projector's Setup menu and verify that Network Status shows as 

 

Connected); if there is no connection refer to the troubleshooting item above 
for more help. 

•

Make sure the Network item in the Always-On Functions submenu in the 
Setup menu is set to Yes (if it is set to No, the projector web pages will only be 
available when the projector is powered on).

•

If scheduled tasks are not performed, check if the SNTP is set up 

 

correctly and is online. Also check if the Command sequence is correct.

•

If automatic emails are not sent, check if SMTP is set up correctly and is 
online.

To manually restart the projector network subsystem: Use the projector's 
remote control or keypad to select the Network item in the projector's Setup menu. 
Then scroll down and select either Restart Network (to restart the network 
subsystem without changing any settings), or Network Factory Reset (to return all 
network settings back to default values, and then restart the network subsystem). If 
the manual restart procedure does not work: To force the network subsystem to 
restart, disconnect the projector from AC power, wait 10 seconds, then reconnect 
AC power.