Infocus IN100 Benutzerhandbuch
Operation
20
Operation
Starting up the projector
1.
Plug the power cord into the projector and
into a wall socket. Turn on the wall socket
switch, if applicable. Check that the
into a wall socket. Turn on the wall socket
switch, if applicable. Check that the
POWER
indicator light on the projector lights
orange after power has been applied.
orange after power has been applied.
2.
Remove the lens cap. If it is closed, it could
become deformed due to the heat
produced by the projection lamp.
become deformed due to the heat
produced by the projection lamp.
3.
Press
POWER on the projector or
remote control to start the projector. The
POWER indicator light flashes green and
stays green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
POWER indicator light flashes green and
stays green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
•
If the projector is still hot from previous activity, it will run the cooling fan for
approximately 90 seconds before energizing the lamp.
approximately 90 seconds before energizing the lamp.
•
To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before
turning it off.
turning it off.
4.
If you are prompted for a password, press the arrow keys to enter a six-digit
password. See
password. See
for details.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input signals. The current input signal
being scanned displays in the upper left corner of the screen. If the projector
doesn't detect a valid signal, the message '
being scanned displays in the upper left corner of the screen. If the projector
doesn't detect a valid signal, the message '
No Signal' will continue displaying
until an input signal is found.
You can also press
You can also press
SOURCE on the projector or remote control to select your
desired input signal. See
for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range'
see the message 'Out of Range'
displayed on a blank screen. Please change to an input signal
for details.
I
I