Infocus IN10 Benutzerhandbuch
4
1
Plug the power cord into the projector
and into an electrical outlet
2
Press the power button
3
Wait for the lamp to warm up
The power light will start blinking green.
After a few seconds, the power light will stop blinking and
stay green . It can take a minute for the lamp to reach full
brightness.
stay green . It can take a minute for the lamp to reach full
brightness.
If the picture isn’t visible, keep pressing the source/select
button until you see it. Wait a few seconds between each press.
button until you see it. Wait a few seconds between each press.
On most laptops, hold down the Fn key and press the function
key labeled CRT/LCD, LCD/VGA, , or similar.
key labeled CRT/LCD, LCD/VGA, , or similar.
Warning: Do not look directly into the lens
when the projector is turned on.
when the projector is turned on.
If there’s still no picture: Restart your computer.
See Troubleshooting for more help.
See Troubleshooting for more help.
5-10 sec.
Apple F7
Dell Fn+F8
Fujitsu Fn+F10
Dell Fn+F8
Fujitsu Fn+F10
ThinkPad Fn+F7
Toshiba Fn+F5
Toshiba Fn+F5
Gateway Fn+F3 or Fn+F4
HP/Compaq Fn+F4 or Fn+F6
Sony Fn+F7
HP/Compaq Fn+F4 or Fn+F6
Sony Fn+F7
Turn on the projector
i
i
5
Turn on the computer
or other source
6
Show the picture
Got a laptop? You may need to
enable its external video port
enable its external video port
The power light on the projector will light amber.
Key combos for more laptops at www.infocus.com/support