Aiptek V50 Benutzerhandbuch

The internal battery of the device may not be fully charged when 
you use the projector for the first time. You can charge the battery 
in the following two ways: 

● 

Plug the AC power adapter into the DC-IN jack of the device, 
and connect the other end to the power source. 

● 

Connect the small end of the supplied USB cable to the USB 
port of the device, and the large end to a powered PC. Make 
sure the projector is powered off. 

 

Power OFF, charging by AC power adapter 

around 3 hours 

Power OFF, charging by USB connection 

around 8 hours 

Power ON and connect AC power adapter 

no charging 

Power ON and connected with USB cable 

no charging 

 

During charging, the LED on the device indicates the level of the internal battery: 

● 

 

- battery charging 

● 

- battery full 

 

  When using a PC to charge the battery, always turn off the projector. Otherwise, the 

charge will stop. 

 
 

Open the cover of the SD Card Slot. Close the cover of the slot. 
Hold the SD card by the edges and gently insert it into the slot (as 
shown below) until it reached the bottom of the slot. 

 
 

To remove the memory card, gently push the top edge of the card 
inwards and it will pop up slightly, then pull the card out of the slot. 

 
 

Use the USB Host cable and connect the small end with the USB Connector of the 
Projector. Connect the USB dongle on the big end of the cable.