Pitney Bowes DM525 Benutzerhandbuch

c. If the tank is still not 

filled to the correct 
level, remove the moist-
ener tank and drain it 
over the front of the 
machine, then replace 
the tank and check the 
level again after 5 min-
utes.

14. Once you verify that the 

moistener tank is filled to 
the correct level with E-Z 
Seal® Solution, gently push 
the tank all the way back to 
its original position. 

Replace the moist-
ener brush assembly 
by pushing it back on 
its track until it snaps 
into position. 
Check to make sure 
that the flap blade of 
the moistener brush 
assembly is under 
(and not over) the 
stripper finger as 
shown here.

15. Verify that the moist-

ener brush assembly 
is perfectly level with 
the feed deck. 

16. Close the feed cover. 
17.



The printer components, consisting of the printer nozzle, ink cartridge and 
printhead, require minimum maintenance to ensure clean, clear meter 
imprints on your mail. 

If the print quality deteriorates and you cannot improve it with the proce-
dures in this chapter, contact the Pitney Bowes Help Desk. Refer to the 



Pitney Bowes Contact Information List at the front of this guide for the 
phone number. 

Stripper



finger

Flap



Blade

Feed



deck

Moistener Brush 
Assembly