Pitney Bowes DM525 Benutzerhandbuch

When you change the printhead, you must also replace the wiper blade 
assembly.

Instructions for replacing the wiper blade assembly are included with each 
replacement and are repeated here for your convenience. 

1. From the IntelliLink® Control Center, press the Menu key.
2. Select Maintenance.
3. Select Replace Wiper Blade Assembly.

The “Preparing Wiper Blade” screen appears. During this time, the sys-
tem moves the printhead assembly back so that you can access the 
wiper blade assembly.

4. The “Replace Wiper Blade Assembly” screen appears instructing you to 

remove the wiper blade assembly from the package.

5. Lift the main cover and 

locate the wiper blade 
assembly. 

6. Push the wiper blade tab 

toward the back of the 
machine. This causes the 
wiper blade to slide to the 
left.

7. Lift the wiper blade up 

and out of the assembly 
and discard.

8. Place the new wiper blade 

in the assembly with the 
two white prongs facing to 
the right. Slide it to the 
right until it snaps into 
place.

9. Close the main cover; the 

“Initializing Wiper Blade” screen appears. 

9. Once the initializing is complete, the “Print Test Pattern” screen appears 

and prompts you to “Press Tape or print an envelope”.

10. You must perform the print test at this time. Follow the prompts, or refer 

to Printing a Test Pattern in this chapter for more information. 

Wiper blade assembly

Wiper blade assembly