Summit E323 Benutzerhandbuch
DOC-0331
Page 5
www.summitlaser.com
Lexmark E-321/E323 Toner Cartridges
(Continued)
Figure 10
Figure 11
Figure 12
Figure 13
7) Remove the two screws on the wiper blade, and the blade. Clean out the waste chamber. The screws for the
wiper blade are smaller than the end cap screws. See Figure 10
wiper blade are smaller than the end cap screws. See Figure 10
NOTE: Be very careful not to damage or distort the thin Mylar Recovery Blade next to the wiper blade. If this blade
is bent or damaged in any way, it should be replaced.
is bent or damaged in any way, it should be replaced.
8) Coat the new wiper blade with your preferred lubricant, and install the wiper blade and two screws. Remember to
use the smaller screws. See Figure 11
use the smaller screws. See Figure 11
9) Remove the fill plug from the toner supply and dump/vacuum out the remaining toner. See Figure 12
10) Remove the screw on the doctor blade spring holder. Remove the entire spring and holder assy. See Figure 13