Summit E323 Benutzerhandbuch
DOC-0331
Page 9
www.summitlaser.com
Lexmark E-321/E323 Toner Cartridges
(Continued)
Figure 26
23) If you have a Prebate cartridge, install the replacement chip in the left end cap. Make sure that the chip is
locked in place by the two plastic tabs. See Figure’s 26 & 27
locked in place by the two plastic tabs. See Figure’s 26 & 27
Figure 27
Figure 28
Figure 29
24) Clean off all the old conductive grease from the left end cap. Reapply new grease to all the contact points in-
cluding a small amount on the drum axle shaft. Remember, when using conductive grease, more is not better. Just
use a small amount on each point. See Figure 28
cluding a small amount on the drum axle shaft. Remember, when using conductive grease, more is not better. Just
use a small amount on each point. See Figure 28
25) Place the large loop of the second spring on the large hopper post. See Figure 29