Summit HL-630 OPC Benutzerhandbuch

 

25

 

 
 

 

These machines have a glass fuse that is used to 

reset the machine.  The fuse is located in the gear 

end cap of the cartridge. We have not confirmed this 

yet, but we believe that the fuse is the same as the 

SF-5100.  The fuse must be replaced each cycle. 

 
 
 
 
 
 

These machines have a glass fuse that is used to 

reset the machine.  The fuse is located in the gear 

end cap of the cartridge. We have not confirmed this 

yet, but we believe that the fuse is the same as the 

SF-5100.  The fuse must be replaced each cycle 

 

 

Although all of these machines use the same 

cartridge, the reset procedures are different. 

 

Turn off the printer 
While holding the MENU1/MENU2 button down, 
turn the printer back on. Keep holding the button 
down until you see "MAINTENANCE MODE" on 
the display panel. Release the button. 
Press the MENU1/MENU2 button three times. The 
display will read "DRUM COUNT RESET". 
Press the ENTER/QUIET button. The display will 
read "DRUM COUNT RESET RESETTING", then 
"INITIALIZING", then "WARMING UP", and 
finally "ON LINE". The counter is reset! 

 
Turn the printer off. 
Press and hold the RESET button (not the Menu 
Reset), and turn the printer on. Hold the button down 
until you see "DRUM RESET" on the display. 
Release the button.  
Run a self-test. Turn the printer off-line and press 
the PRINT  
FONT/SELF TEST button once and release. The 
printer will print out a page with the installed fonts, 
and the page count of the printer.  

Processing Systems. 

 
Turn the DOC-IT on, and re-initialize it: either re-
boot the computer, or type DOCIT at the DOS 
prompt and press enter. 
Press and hold the ENTER key for 3 seconds, when 
you release it you should see "Administration" on 
the display. 
Press the down arrow key until you see: Reset drum 
ctr.? YES/NO 
Press the left arrow key to move the check mark next 
to "YES". Then  
Press ENTER. 
Press any key to leave the Administration menu. 
The counter is reset!