Summit HL-630 OPC Benutzerhandbuch

 

28

 

 (The procedure for these machines is the same as 
used for the Okidata OP-6e, OL-600e, OP-10e) 
 
From the computer the printer is directly hooked up 
to, enter the Printer Status Monitor. Click on the 
“Printer Menu” tab. Click on the “Maintenance” tab. 
Click on the “Drum Counter Reset” tab. 

OEM Stated Yield: 30,000 

(The procedure for these machines is the same as 

used for the Okidata OL-400e, OP-20, & OP-24) 

 
Turn off the printer. While holding the 
MENU1/MENU2 button down, turn the printer back 
on. Keep holding the button down until you see 
USER MNT on the display panel. Release the 
button. 
Press the MENU1/MENU2 button three times. The 
display will read DRUM CTR RESET. 
Press the ENTER button. The display will read 
WARMING UP, and finally ON LINE. The counter 
is reset! 

 

Press the “Menu/Exit” key. Press the “Down Arrow” 
until the display shows “Counter”. 
Press “Enter” twice. Press “Clear” twice.  Press the 
“Menu/Exit” key. The counter is reset! 
 

This cartridge uses an optical reset. The waste 
chamber must be spotless!! There is a float inside 
that moves up as the waste toner increases. There is 
a small clear piece of plastic on the waste chamber 
with a black plastic float inside. This must be 
spotless and the float should be at the base. If this 
piece is dusty, or the float is up the printer will not 
reset. 

 
This cartridge uses an optical reset. The waste 
chamber must be spotless!! There is a float inside 
that moves up as the waste toner increases. If you 
remove the small circuit board on the side you will 
see a small clear piece of plastic. This must be 
spotless and the float should be at the base. If this 
piece is dusty, or the float is up the printer will not 
reset.