Summit HL-630 OPC Benutzerhandbuch

Seite von 46
 
35
 
actuator (or flag) is next to the small gear). On some 
cartridges the "flag gear" is now black. It is located 
to the bottom right of the white gear. Make sure that 
when you snap the green end cap back on, the notch 
on the small gear lines up with the tab on the large 
single gear that is on the cartridge. Once everything 
lines up, snap the end cap in place. This is tricky, 
take your time! 
 
To reset the starter cartridge, or any cartridge 
through the menu, do the following: 
 
 
 
 
 
 
Enter the diagnostics menu by turning the machine 
on, and within 4 seconds, press "CLEAR", 
"EXPOSURE MODE", "CLEAR", "EXPOSURE 
MODE". (EXPOSURE MODE is the button on the 
far left). All of the display will go blank. Using the 
10 and 1 buttons (copy quantity), enter "24" press 
"PRINT", enter "7" press "PRINT" again. The 
counter is now set to Zero! 
 
Sharp AR-150 OPC 
Sharp Cartridge Part # AR-150DR 
OEM Stated Yield: 18,000 
 
To reset the cartridge through the menu, do the 
following: 
Enter the diagnostics menu by turning the machine 
on, and within 4 seconds, press "CLEAR", 
"EXPOSURE MODE", "CLEAR", "EXPOSURE 
MODE". (EXPOSURE MODE is the button on the 
far left). All of the display will go blank. Using the 
10 and 1 buttons (copy quantity), enter "24" press 
"PRINT", enter "7" press "PRINT" again. The 
counter is now set to Zero! 
 
Sharp AL-1641/55/61 OPC 
Sharp Cartridge Part # Al-100DR 
OEM Stated Yield: 18,000 
 
These machines use the AL-110TD toner cartridge 
and have a different reset procedure then the normal 
AL-100DR machines use. 
To reset the cartridge through the menu, do the 
following: 
Enter the diagnostics menu by turning the machine 
on, and within 4 seconds, press “#” “ *”  “
CLEAR”  
*
 
All of the display will go blank. Using the 10 
and 1 buttons (copy quantity), enter "24" press 
"PRINT", enter "7" press "PRINT" again. The 
counter is now set to Zero! 
 
 
Xerox WorkCentre Pro 16 Series OPC 
Xerox Part # 13R563 
OEM Stated Yield: 18,000 
 
The actual procedure for these machines is not 
currently known. It is highly probable that the same 
procedures used in the Sharp AL-1000/Xerox XD-
100 will work but this is still being investigated. 
Look for updates on these machines on our web site 
www.summitechnologies.com 
 
Xerox WorkCentre Pro 215 OPC 
Xerox Part # 13R563 
OEM Stated Yield: 18,000 
 
 The actual procedure for these machines is not 
currently known. It is highly probable that the same 
procedures used in the Sharp AL-1000/Xerox XD-
100 will work but this is still being investigated. 
Look for updates on these machines on our web site 
www.summitechnologies.com 
 
 
 
 
.  
 
 
Sharp AR-152 Toner Cartridges 
Sharp Cartridge Part # AR-152NT 
OEM Stated Yield: 6,500 
 
These cartridges have a “Single Use Killer Chip”. 
This chip shuts down the cartridge after the first 
cycle so it will be necessary to replace it each time. 
Replacement chips for these cartridges are now 
available. The chip is installed in the back of the 
connector on the cartridge.