Summit HL-630 OPC Benutzerhandbuch

 

36

 

 
 

The developer is rated for 25,000 pages. The default 
setting on the machine is to keep running even after 
the 25K pages. That default setting can be set by the 
dealer to stop at 25K pages. It is considered a dealer 
option. 
 
To clear the developer after a stop, or to reset the 
counter, simulation 24-06 must be run. 
 
To enter the simulation mode, press the “CLEAR 
KEY”, EXPOSURE SELECT KEY”, “CLEAR 
KEY”, EXPOSURE SELECT KEY”. 
 
Press 24 
Press 06 
Press “PRINT” The developer count is now cleared. 
 

Inside the drum cover, there is a gear with a “Flag” 
on it. Remove the gear and place it so the flag is at 
the 12:00 position. This flag when the cartridge is 
installed, will turn down, and engage a switch in the 
machine. This tells the machine there is a new drum. 
If the drum unit has never been rebuilt, this flag gear 
is not there. It can be ordered from Sharp, but there 
is also a reset that can be done through the menu. 

 

To clear the drum count if the flag gear is not 
present, simulation 24-07 must be run. 
 
To enter the simulation mode, press the “CLEAR 
KEY”, EXPOSURE SELECT KEY”, “CLEAR 
KEY”, EXPOSURE SELECT KEY”. 
 
Press 24 

Press 07 
Press “PRINT” The drum count is now cleared. 
 
 
 

Inside the drum cover, there are two white gears. 
The larger gear has a white tab that must be placed at 
the 12:00 Position. The smaller gear has two small 
tabs that must also be place at 12:00. 
 
 

These cartridges have a “Single Use Killer Chip”. 
This chip shuts down the cartridge after the first 
cycle so it will be necessary to replace it each time. 
Replacement chips for these cartridges are now 
available. The chip is installed in the back of the 
connector on the cartridge.