Summit HL-630 OPC Benutzerhandbuch

 

45

 

 
 
 

To reset the counter in the 5113 OPC cartridges the 
connector on the rear of the cartridge must be 
replaced. This will clear the J7 or J8 codes.  J7= 
change copy cartridge, J8 = wrong or bad connector. 
 
There are many different cartridges that use different 
connectors for these machines. A list of some of 
them is as follows: 113R79/113R80/113R85 (US), 
113R86 (US connector works), for the 
113R81/113R82 cartridges no connectors are 
available. 
 
If you are outside the US, and are not sure what type 
of connector to use, it is possible to find out by 
going into the machines diagnostics. To do this turn 
the machine off, press the “0” while turning the 
power on. Enter “3” and press print, enter “3” again 
and press print. The display will show the installed 
cartridge type. 4=US,  and Europe 5113/5114 7 = 
Europe 5614. 
 
NOTE: Although the Sharp 2014/2114 cartridges 
appear similar, they are not. The Sharp cartridges do 
not have a counter (they are reset through the menu), 
and the gears are different. 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 

 
To reset the counter in the 5312/14 OPC cartridges 
the connector on the rear of the cartridge must be 
replaced. This will clear the J7 or J8 codes.  J7= 
change copy cartridge, J8 = wrong or bad connector. 
 
There are many different cartridges that use different 
connectors for these machines. A list of some of 
them is as follows: 13R62/62 (US), 13R61 US (5313 
Only!), 13R65/13R66 (RX), 13R517 (XCL), 13R63 
(XLA), 13R518 (XCL). It should be noted that the 
5313 uses a different connector than the 5312/14 
cartridges and that they are NOT interchangeable. If 
you are outside the US, and are not sure what type of 
connector to use, it is possible to find out by going 
into the machines diagnostics. To do this turn the 
machine off, press the “0” while turning the power 
on. Enter “31” and press print. The display will 
show 00,00,XX. The XX being the installed 
cartridge type. 17=US, 51 = 5313, 85 = Rank Xerox. 

These cartridges have two small fuses that must be 
replaced each cycle.  The old fuses must be un-
soldered from the circuit board on the connector, and 
the new soldered in. Be very careful not to damage 
the board with too much heat.