Summit HL-630 OPC Benutzerhandbuch

Seite von 46
 
9
 
 
 
 
 
 
HP Color LaserJet 3700 
HP Black # Q2670A, Cyan Q2681A, Yellow 
Q2682A, Magenta Q2683A 
OEM Stated Toner Yield: 6000 Black, 6000 Color 
 
These cartridges have what HP now calls “Smart 
Chips” Similar to other HP chips, these chips 
monitor toner usage, Internet supplies ordering, and 
a new feature, remote troubleshooting. Unlike the 
4100, the chips need to be replaced every cycle. 
There are separate chips for each color. These 
cartridges are “all in one” where the toner, drum, and 
waste are all contained in one cartridge. These 
machines share the same black cartridge as the CLJ 
3500. The colors are not interchangeable. Toner and 
chips are in development. 
 
 
 
 
 
 
 
HP Color LaserJet 3800 
HP Black # Q6470A, Cyan Q7581A, Magenta 
Q7583A, Yellow Q7582A 
OEM Stated Toner Yield: 6000 Black, 6000 Color 
 
These cartridges have what HP now calls “Smart 
Print Technology Chips”.  These are the latest in HP 
chips, they are very small, and contain all new code. 
As with most HP chips, these chips monitor toner 
usage. The chip does not need to be replaced, but if 
it is not, “Unauthorized cartridge” will show on the 
display. New chips are now available. These 
cartridges are “all in one” where the drums included 
with the toner. New toner and chips are available. 
 
 
 
 
 
 
 
 
 
 
 
HP Color LaserJet 4500 (Canon 
LBP-83X) 
 
HP-4500 General Note:  If the transfer belt kit or 
Fuser is replaced before the change fuser/transfer 
messages are displayed, placing a new part in the 
machine may not reset the counter. Reset procedures 
for these parts are included here.   
 
OPC Cartridge 
HP OPC Part # C4195A 
OEM Stated Yield: 25,000 
 
These cartridges have an ARD installed on the left 
side of the cartridge. The chip is actually just an IC 
plugged into a socket on the back of the electrical 
connector, which can easily be changed. It would 
seem that HP or Canon has plans to recycle these 
cartridges. Even though they look the same, the 
programming on these chips is different from the 
HP-8500. 
 
New reset chips are now available to reset these 
cartridges. Drums and chips should be sold as a set 
as the chip contains information about the drum 
sensitivity. These cartridges also have windows that 
work with an optical sensor inside the printer that 
determines if the waste chamber is full or not. It is 
more than likely that if the waste chamber fills up, 
the machine will shut down. We are not sure if the 
cartridge waste chamber is cleaned out, it will 
continue to run until the chip finishes its page count. 
The Canon version of this printer is the CLBP-
460PS. The chip also contains information on the 
characteristics of the drum that is used during the 
calibration sequence.