Toshiba B-SA4TM-TS12-QM-R Benutzerhandbuch
7. SUPPLY SPECIFICATIONS
ENGLISH VERSION EO1-33047
7.2 Ribbon
E7- 8
(11) Print Position Accuracy
When using RFID tag embedded media, the print position accuracy may exceed the guaranteed tolerance of
When using RFID tag embedded media, the print position accuracy may exceed the guaranteed tolerance of
±1
mm in all issue modes.
It is required to check the print position accuracy for each media type.
(12) Paper Jam Error
Depending on the type of glue or the flexibility of labels, a label may come unstuck in front of the sensor unit,
which cause a paper jam. Particularly, the frequency of paper jam could become higher on the condition of low
operating temperature or use of short-pitch labels.
It is required to check the media feed using the media to be used under the actual operating environment.
It is required to check the print position accuracy for each media type.
(12) Paper Jam Error
Depending on the type of glue or the flexibility of labels, a label may come unstuck in front of the sensor unit,
which cause a paper jam. Particularly, the frequency of paper jam could become higher on the condition of low
operating temperature or use of short-pitch labels.
It is required to check the media feed using the media to be used under the actual operating environment.
7.2 Ribbon
Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a TOSHIBA TEC service
representative.
Type Spool
type
Width
60 – 110 mm
Recommended width is 60, 90, and 110 mm.
Recommended width is 60, 90, and 110 mm.
Length
450 m (within
∅75 mm)
Outside Diameter
∅75 mm (max.)
The table below shows the correlation between ribbon width and media width (backing paper is not included.)
Ribbon width
Media width
60 mm
25 – 55 mm
90 mm
55 – 85 mm
110 mm
85 – 105 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. Too much difference in width between media and ribbon may cause ribbon wrinkles. To avoid ribbon
2. Too much difference in width between media and ribbon may cause ribbon wrinkles. To avoid ribbon
wrinkles use a ribbon for proper media width shown in the above table. Do not use a ribbon that is narrower
than media.
than media.
3. When discarding ribbons, please follow the local rule.