Toshiba B-SX4T Benutzerhandbuch

ENGLISH VERSION EO1-33058 

2.9 Setting an Operating Environment

E2-29 

 
 
 

(26)  Label End/Ribbon End Selection 
This parameter is to choose a printing process when a label end or ribbon 
end is detected.   
When “<2>PARAMETER SET” appears, press the 

[PAUSE] key until 

the following display appears. 
 
 
 
 
Use the 

[FEED] or [RESTART] key to select a desired option. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
After selecting a Label End/Ribbon End type, press the 

[PAUSE] key. 

 
 

(27) Pre-Strip Selection 
This parameter is to choose whether to activate the Pre-strip function.   
When this parameter is set to ON (Available), the top edge of a label is 
separated (pre-stripped) from the backing paper before the label is printed.  
This function is intended to make the strip issue easier in case the labels 
are hard to strip due to the label intensity, adhesive power, or the printing 
speed. 
When “<2>PARAMETER SET” appears, press the 

[PAUSE] key until 

the following display appears. 
 
 
 
 
Use the 

[FEED] or [RESTART] key to select a desired option. 

 
 
 
 
 
 
 
After selecting the Pre-strip function, press the 

[PAUSE] key. 

 

<2>PARAMETER SET 

LBL/RBN END TYP1 

LBL/RBN END TYP1 

LBL/RBN END TYP2 

TYPE1: When a label/ribbon end is 
detected in the middle of printing, 
printing is immediately paused. 

TYPE2: When a label/ribbon end is detected 
in the middle of printing, the printer prints the 
half-finished label as far as possible, and 
stops when the next label is at the home 
position.  

<2>PARAMETER SET 

PRE PEEL OFF OFF 

PRE PEEL OFF OFF 

PRE PEEL OFF  ON 

Unavailable 

Available