Tally Genicom 6600 Benutzerhandbuch

182

This command allows you to change the current/default Special Function 
Control Character to one of your choosing. SFCC command characters may 
be selected from ASCII characters in Hex address 00-FF. The SFCC 
command is:

NOTE: In addition to being able to change the SFCC using this command we 

have added the ability to change it through the printer control panel. 
The SFCC Parameter is located in the Configurations Menu.

To change the SFCC from the default character (~, tilde) to the @ 
character use either the following commands:

SFCC;

Special Function Control Character 
(SFCC)

Enter the current Special Function Control 
Character followed by SFCC, then end the 
entry with the parameter delimiter.

n

Designates the new SFCC 
Command Character.

Enter desired ASCII character in decimal 
format. The valid range of values is from

 

0 - 255. 
You may also use the optional method of 
actually specifying the desired character, if 
it is a printable character, by using the 
format ‘n’ to designate the character. If you 
use this method enter the desired printable 
character between single quote 
characters.