Tally Genicom 8026DN Benutzerhandbuch

Jun 06

TallyGenicom Intelliprint 8026DN Color Laser Printer User Guide

The system menu provides access to system settings. Use the following procedure to enter the 
system menu:

1. Press the MENU button on the control panel.

2. Press the NEXT button until the text “System Menu” is shown on the second line of the 

display.

3. Press the SELECT button to enter the system menu.

4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-

guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, Toner 
Low, Page Compression, and Intellifilter.

5. Press the SELECT button to enter a submenu.

Use the procedures in the following table to access and change the system settings:  

FACTORY DEFAULTS
This submenu allows you to reset 
the printer to U.S. or Non-U.S. 
factory defaults.

U.S.

U.S.
Non-U.S.

 1. Press NEXT or PREVIOUS to 

toggle between U.S. and NON-U.S. 

 2. Press SELECT to choose and set 

the factory defaults.

DISPLAY LANGUAGE
This submenu allows you to 
change the language of the 
display messages. 

English

English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish)
…

 1. Press NEXT or PREVIOUS to scroll 

through the available languages.

 2. Press SELECT to choose and set 

the language.

POWER SAVER
This submenu allows you to 
change the time (in minutes) when 
the printer enters the Power Saver 
Mode. 

15

1 to 999

 1. Press NEXT or PREVIOUS to 

select the number of minutes. 

 2. Press SELECT to choose and set 

the time.

WAIT TIMEOUT
This submenu allows you to 
increase or decrease the length of 
time (in seconds) that the printer 
will remain in the waiting state—a 
job is being processed, no 
end-of-file has been detected, and 
there is no more data to process. 
This setting applies to both PCL 
and PostScript print jobs.

00020

0 – 99999

 1. Press NEXT or PREVIOUS to 

increase or decrease each digit of 
the five-digit number.

 2. Press SELECT set one digit and 

move to the next digit.

 3. Press SELECT after changing the 

last digit to save this setting.