Citizen Systems iDP-3540/3541 Benutzerhandbuch
iDP-3540/41 User’s Manual
CITIZEN
18/48
6-6. Self Test Printing
Your printer has a built in self print function for purpose of checking print operation without
the need for any other external device.
the need for any other external device.
Procedures for Actuating the Print Function
1) Be sure that a paper roll is properly loaded.
2) Confirm that the ribbon cassette is properly installed and turn the power switch off.
3) Turn the power switch ON while pressing the LF switch, and release the LF switch after the self
test operation has begun.
1) Be sure that a paper roll is properly loaded.
2) Confirm that the ribbon cassette is properly installed and turn the power switch off.
3) Turn the power switch ON while pressing the LF switch, and release the LF switch after the self
test operation has begun.
In the above operation, the self print function will stop automatically when completed.
However, the self print function will not operate without paper.
However, the self print function will not operate without paper.
6-7. Alarm and Paper Near-End Detection
This printer has the paper near-end sensor to stop the operation when the paper comes to near-end,
sending out both BUSY and FAULT signals. This status is indicated by the SEL / ALARM lamp
blinking at an interval of 1.0 second.
sending out both BUSY and FAULT signals. This status is indicated by the SEL / ALARM lamp
blinking at an interval of 1.0 second.
7. Input Buffer Back-up Function
7-1. Input Buffer Back-up
If the power is turned off, or there is a power failure during printing, the data in the input buffer will
be retained. When the power comes back on, the power failure symbol (…..PD) will be printed,
and then the data which was interrupted will be printed from the beginning of the line where the
interruption occurred.
be retained. When the power comes back on, the power failure symbol (…..PD) will be printed,
and then the data which was interrupted will be printed from the beginning of the line where the
interruption occurred.
Note: The input buffer back-up function may not operate properly if the related capacitor is not
sufficiently charged. This may be the case if the printer has not been operated for a long period of
time. After the printer power switch has been turned on for 10 minutes, the buffer back-up should
be effective for approximately 24 hours or more.
sufficiently charged. This may be the case if the printer has not been operated for a long period of
time. After the printer power switch has been turned on for 10 minutes, the buffer back-up should
be effective for approximately 24 hours or more.
7-2. Clearing the Input Buffer
In case it is desired to delete the data in the input buffer, the power switch should be turned on
while pressing the SEL switch. When deletion of the buffer is completed the buzzer will sound.
Please be sure to continue pressing the SEL switch until that time.
while pressing the SEL switch. When deletion of the buffer is completed the buzzer will sound.
Please be sure to continue pressing the SEL switch until that time.
If the printer fails to work properly at the time the power switch is turned on, please delete the input
buffer as described above before inputting new data.
buffer as described above before inputting new data.