Citizen Systems CD-S500 Benutzerhandbuch

This printer can be installed horizontally or vertically and can be wall mounted.
But according to the model you are using, there may be restrictions on how it is installed.
Refer to the following table.

*

1

: Accessory rubber feet must be used to prevent slipping.

*

2

: The optional specialized wall mount unit is necessary to mount it on the wall.

 Removing the Chassis Platen L Spring

1

. Open the rear cover. Do this carefully, because

the cover snaps open vigorously.

2

. Lift part A with the fingers of your right hand.

3

. Switch the Chassis Platen L Spring that you have

raised from your right thumb to your left thumb
to hook the protrusion on the end of the Chassis
Platen L Spring inside part B of the printer.

To install the printer vertically or wall mounted, remove the Chassis Platen L Spring used to
open the rear cover. And reverse the LED name sheet on the operation panel to use it with
the vertically installed and wall mounted display.

Chassis Platen 
L Spring

Part A

Protrusion

Part B

Chassis  Platen  L  Spring  with  strong
repulsive force is used. Be very careful
that  it  does  not  slip  off  your  finger
causing an injury.

 LED Name Sheet

Remove and reverse the sheet then reinsert the
protruding part of the center of the sheet in the
printer and push in both ends.

Standard model (AC adapter type)

Yes

No

Yes*

2

Standard model (Built-in AC adapter type)

Yes

Yes*

1

Yes*

2

Auto cutter equipped model (AC adapter type)

Yes

No

Yes*

2

Auto cutter equipped model (Built-in AC adapter type)

Yes

Yes*

1

Yes*

2

Auto cutter and rewinder equipped model

Yes

No

No

(AC adapter type)

Auto cutter and rewinder equipped model

Yes

No

No

(Built-in AC adapter type)