Citizen Systems PROdot 350 Benutzerhandbuch
- 17 -
Using Passbooks
Turn the printer on.
Then press the PARK/LOAD key
to set the paper select lever at the
cut-sheet position as shown in the
figure below.
to set the paper select lever at the
cut-sheet position as shown in the
figure below.
Note: You should NOT change
this setting manually. Always use
the control panel key.
this setting manually. Always use
the control panel key.
Position the left hand guide in the
correct location for the size of paper being used.
correct location for the size of paper being used.
Before inserting the passbook in to
the printer, flatten it as shown in
the figure below.
the printer, flatten it as shown in
the figure below.
If the binding stitch area is
projecting outward when the
passbook is opened, flatten it
using a pencil or similar as
shown in the figure. This is to
ensure the passbook is feed
smoothly through the printer
and to avoid any damage to the printhead.
projecting outward when the
passbook is opened, flatten it
using a pencil or similar as
shown in the figure. This is to
ensure the passbook is feed
smoothly through the printer
and to avoid any damage to the printhead.
Note: Do not feed irregularly shaped passbooks nor passbooks who’s
pages are covered in a smooth coating otherwise improper printing and
damage may occur.
pages are covered in a smooth coating otherwise improper printing and
damage may occur.