Citizen Systems CBM920II Benutzerhandbuch
— 34 —
7. DIP SWITCH (SW1) SETTING
7.1 DIP Switch Position
DIP switch (SW1) is located at the back of the printer as shown in the figure below.
The polarity and part of the function of the switch differs depending on the interface.
For memory switch setting, refer to “4.9 Setting Memory Switches”.
The polarity and part of the function of the switch differs depending on the interface.
For memory switch setting, refer to “4.9 Setting Memory Switches”.
NOTE
Before setting, turn the printer power off.
Do not use edged object, such as a pen, to change the switch.
Do not use edged object, such as a pen, to change the switch.
1
ON
2 3 4 5 6 7 8
1
ON
2 3 4
Serial
Parallel
7.2 Parallel Interface Type
*: Difference may occur in accordance with the emulation set by the memory switch.
After setting DIP switch No. 4 to ON, turning the printer power on with the SEL switch
pressed and held causes the printer enter the Manual memory switch setting mode.
After manual setting mode, be sure to set this switch to OFF.
pressed and held causes the printer enter the Manual memory switch setting mode.
After manual setting mode, be sure to set this switch to OFF.
Switch No.
Function
OFF
ON
Factory Setting
1
Character direction
Normal
Inverted
OFF
2 (920)*
CR command
Ignore CR
CR + LF
OFF
2 (3110)*
CR command
CR
LF
OFF
3
RESET in
Disable
Enable
ON
4
Memory switch
Disable Setting
Enable Setting
OFF